The ISO 899-1 2003 is an international standard with the title: Plastics Determination of creep behaviour. Tensile creep

ISO 899-1:2003 specifies a method for determining the tensile creep of plastics in the form of standard test specimens under specified conditions such as those of pretreatment, temperature and humidity.

The method is suitable for use with rigid and semi-rigid non-reinforced, filled and fibre-reinforced plastics materials (see ISO 472 for definitions) in the form of dumb-bell-shaped test specimens moulded directly or machined from sheets or moulded articles.

The method is intended to provide data for engineering-design and research and development purposes. Data for engineering-design purposes requires the use of extensometers to measure the gauge length of the specimen. Data for research or quality-control purposes may use the change in distance between the grips (nominal extension).

Tensile creep may vary significantly with differences in specimen preparation and dimensions and in the test environment. The thermal history of the test specimen can also have profound effects on its creep behaviour. Consequently, when precise comparative results are required, these factors must be carefully controlled.

If tensile-creep properties are to be used for engineering-design purposes, the plastics materials should be tested over a broad range of stresses, times and environmental conditions.

Quelle: 130106/2006-10-31

 

Related Articles

Iso 899-2 2003 ■■■■■■■■■■
Iso 899-2 2003: Title: Plastics. Determination of creep behaviour. Flexural creep by three-point loading; . . . Read More
Iso 178 2001 ■■■■■■■■■■
Iso 178 2001: Title: Plastics - Determination of flexural properties of rigid plastics; - - ISO 178:2001 . . . Read More
Iso 974 2000 ■■■■■■■
Iso 974 2000: Title: Plastics. Determination of the brittleness temperature by impact; - - ; ; ISO 974:2000 . . . Read More
Iso 62 1999 ■■■■■■
The Iso 62 1999 is a standard with the title: Plastics. Determination of water absorption; - - ISO 62:1999 . . . Read More
Iso 1268-9 2003 ■■■■■■
Iso 1268-9 2003: Title: Fibre-reinforced plastics. Methods of producing test plates. Moulding of GMT/STC; . . . Read More
Iso 11342 1998 ■■■■■
Iso 11342 1998: Title: Mechanical vibration. Methods and criteria for the mechanical balancing of flexible . . . Read More
Iso 1132-1 2000 ■■■■■
The Iso 1132-1 2000 is a standard with the title Title: Rolling bearings. Tolerances. Terms and definitions; . . . Read More
Iso 1217 1996 ■■■■■
The Iso 1217 1996 is a standard with the Title: Displacement compressors. Acceptance tests; - - ; ISO . . . Read More
Iso 5-4 1995 ■■■■■
Iso 5-4 1995: Title: Photography. Density measurements. Geometric conditions for reflection density; . . . Read More
ISO 14855 ■■■■■
- ISO 14855:1999 : Determination of the ultimate aerobic biodegradability and disintegration of plastic . . . Read More